Page 1 of 1

problem getting audio into my monitors.

Posted: Mon Dec 01, 2014 11:46 am
by lennox
Hello friends, I recently bought a mac mini to use as my home studio computer. I have an M-Audio control surface and studio monitors hooked up to channels 1/2. My problem is I'm not quite sure how to map out what I need to do to get audio from my mandalas to my monitors.

My mandalas are lighting up when I strike but I'm not getting any sound out of my speakers. I'm pretty new to Mac so I've been trying to do a "Process of elimination" but I'm not getting any results.

If anyone could help me I'd really appreciate it.

Thanks guys, James

Re: problem getting audio into my monitors.

Posted: Thu Dec 04, 2014 8:41 pm
by turnkee
If you follow the setup steps in the Mandala manual (downloadable from the Mandala site) for the audio driver page you'll probably get it going pretty quick. The Test Tone button is the key to knowing when you are set up properly.

Re: problem getting audio into my monitors.

Posted: Fri Dec 05, 2014 7:18 pm
by Yoshi71
I recently had that problem. I hooked up my Mandala to my laptop and it was showing that I was striking it but..no sound. I downloaded the newest software, and it worked like a breeze. Perhaps you just needed the newest software? Good luck!